Repair Service for Adaptive Cruise Control (ACC) and Braking Guard Camera Module, commonly found in 2010 - 2018 Audi A6/A7/A8 and 2010 - 2018 VW Touareg vehicles.
Failure of ACC Camera module will typically result in the following fault/DTC within the Image Processing Control Module:
0161 - Video Cable for Image Processing C1107 02 - Signal Failure
Upon arrival, each module is bench tested by Live Simulation on specially designed Test Bed to confirm initial diagnosis.
Tier 1 Repair (applies to most modules) involves a re ball and reinstall procedure utilizing the original / existing Virtex FPGA BGA IC.
In some rare cases the module may not be reparable with Tier 1 procedure (re ball / reflow procedure utilizing the original Virtex FPGA IC), which would indicate an actual FPGA IC failure. In those cases, the Virtex FPGA IC will need to be replaced.
Tier 2 Repair involves replacement of Virtex FPGA IC with a New Component. There will be a $200 additional fee if FPGA IC replacement is required. Original FPGA IC will be returned as proof of replacement.
ACC Camera Module retains all coding and calibration settings. If the module is reinstalled in the original vehicle, VIN, Component Protection coding and/or calibrations are not required, as there are no changes made to coding / calibration / adaptation during the repair process.
2 Year Warranty.
3-5 day Service Turnaround time.
Please contact us if there had been previous repair attempts, as this may have resulted in Virtex FPGA IC Chip being overheated / damaged and require replacement (typically require Tier 2 Level Repair).
Please contact us with specific questions regarding this service.
4G0 907 217
4G0 907 217A
4G0 907 217B
4H0 907 217A
7P6 907 217B
2010-2018 Audi A6/A7/A8
2010-2018 VW Touareg
Collision Avoidance Camera
4G0-907-217; 4H0-907-217-A; 4H0-907-217-B; 4G0-907-217-AX
7P6907217BZ1Y; 7P6-907-217-B-Z1Y; 7P6-907-217-BZ1Y; 7P6907217AZ02; 7P6907217AZ06; 7P6907217B Z1Y; 7P6907217Z0E
